Bulk Picture Hanging Hardware & Supplies
 
Home > Art Hangers > Wood Frame >
strap hanger with four screws hwr-800
  • strap hanger with four screws hwr-800
  • Medium Strap Hanger - HWR-800
  • strap hanger with four screws hwr-800
  • narrow strap hanger 3 1/4 inch long 4 hole
  • narrow strap hanger 5/8 inch wide four hole
  • narrow four hole strap hanger for wood frames

Medium Strap Hanger

  • Narrow Four Hole Strap Hanger for Wood Frames
  • 3 1/8" Long x 5/8" Wide
  • Strap part only is 3/8" wide
  • Includes #6 x 1/2" screws
  • Holds up to 20 pounds
  • Steel ring held by a doubled-over steel strap with multiple screw holes to reduce possibility of the screw tearing out
  • Can be used as the art hanger or in conjuction with wire
Item # Description/Size Price Quantity
HWR-800X
Medium Strap Hanger - 10 Pack
 $6.50
HWR-800C
Medium Strap Hanger - 100 Pack
 $21.75
HWR-800M
Medium Strap Hanger - 1,000 Pack
 $162.50
HWR-800V
Medium Strap Hanger - 5,000 Pack
 $627.50

    1. Place the frame face down on a blanket or soft surface.
    2. Strap hangers can be used in conjunction with heavy Picture Wire on larger, heavier wood frames.
    3. When used with wire, strap hangers should be installed on the frame side rails, between one-quarter and one-third of the way down from the top of the picture.
    4. Measure and mark this distance equally both side rails.
    5. If the frame width allows, position the hangers in alignment with the angle the picture wire will take when the frame is hung and the wire is under tension.
    6. Pre-drill for all screw holes to avoid splitting the wood of the frame. Take care not to drill through to the front surface of the frame.
    7. Install the strap hangers on the frame with appropriate length screws.
    8. Attach heavy picture wire to the hangers using the method illustrated here.
    9. Leave enough slack in the wire so that when it is pulled taut up against the back of the frame, the center point of the wire reaches about half the distance between the hanger position and the top of the frame.
    10. Hang the picture on heavy Picture Hooks or wall anchors.
    11. Strap hangers can also be used without wire, aligned vertically at the top corners of the frame. The rings of the hangers are then placed directly on picture hooks previously nailed into the wall.
    12. When used in this manner, make sure that the hangers are positioned on the frame an equal distance down from the frame's top edge. Also make sure that the picture hooks are perfectly level on the wall and spaced apart the same distance as the distance between the hangers on the frame.
    13. When used without wire, be sure to place strap hangers down far enough from the top edge of the frame to allow the frame to hide the picture hooks when the picture is hung on the wall.