Bulk Picture Hanging Hardware & Supplies
Brick & Concrete Hooks
Picture Rail Hooks
Specialty & Museum Hooks
Brass Gallery Rods
Cable Hanging System
Clear Nylon Cord
Stainless Steel Wire
Vinyl Coated Wire
3/8" Diameter .150" Height Black Dome Rubber Bumper
Black Molded Polyurethane Self Adhesive Bumper
Dome or Hemispherical shaped bumper
Diameter 3/8" and Height .150"
Diameter 9.5 mm and Height 3.8 mm
Excellent Abrasion Resistance and non-staining or marring
Dome Rubber Bumper recommended for Metal Frames
Black Dome Rubber Bumper 3/8" - 100 Pack
Black Dome Rubber Bumper 3/8" - 1,000 Pack
Black Dome Rubber Bumper 3/8" - 5,000 Pack
Lay the frame face down on a blanket or soft surface.
The bumper application area on the back side of the frame should be smooth, clean, free of debris, dry, not greasy or oily.
You will need to place one bumper at each bottom corner of the frame only--bumpers are not needed at the top of the frame.
For metal frames, a dome-style rubber bumper should be applied on top of the steel corner connecting plate at each of the frame's bottom corners.
For wood frames, a flat-style rubber bumper should be applied close to but not over the edge of the frame at each bottom corner.
If more standoff distance from the wall is required, use our higher cylindrical rubber bumper .
Pick rubber bumpers from the pad by grasping them on the sides between thumb and forefinger. Do not touch the bumper's adhesive surface.
Press bumpers firmly into place. Once a bumper is in place, do not attempt to reposition it--this will ruin the adhesive bond.
Frames may be hung immediately, but there is a 24-hour dwell time after bumper application before maximum adhesion is reached.
Write a review!
Read all reviews