product images on this page are shown in black & white
Hanger 7-10" HWR-114 BULK
PRICING: $1.66 for 25-49 $1.58 for 50-99
$1.49 for 100 or more
Plate Hanger 7-10"
BULK PRICING: $1.66 for 25-49 $1.58 for 50-99 $1.49 for 100 or more
Hanger 10-14" HWR-115 BULK
PRICING: $1.85 for 25-49 $1.76 for 50-99
$1.66 for 100 or more
Plate Hanger 10-14"
BULK PRICING: $1.85 for 25-49 $1.76 for 50-99 $1.66 for 100 or more
A plate hanger consists of two W-shaped brass-plated wire brackets that are connected together by two steel coil springs. The hooked ends of the brackets are covered with clear plastic sleeves to protect the plate front surface and edges.
Hanging a plate with a plate hanger is straightforward. Working from the back side of the plate, the hooked ends of one bracket are placed over the edge of the plate, then the hooked ends of the other bracket are placed over the opposite edge. The connecting coil springs hold the brackets in place under tension. The plate then can be hung on a standard picture hook placed in the wall. For full instructions go here.
When a plate is hung on the wall, only the hooked-over tips of the brackets are visible, everything else is hidden behind the plate. See plate hanger front and back views here.
Plate Hangers are available in three sizes:
Please be sure to keep within the above size guidelines when using plate hangers.
If a plate hanger is too loose on a plate, the plate can slip off the hanger. If a plate hanger is too tight on a plate, the plate and/or the hanger can be damaged.
For safety's sake, do not use plate hangers on large, heavy, deep or irregularly shaped plates. Such items are best displayed on easels or special plate shelves.
When stretching plate hangers on a plate, care must be taken not to scratch or otherwise mar the back surface of the plate with the coil springs. If the condition of the back side of a plate is a consideration, or if the plate is very valuable or collectable, it should probably be displayed in another manner.
Plate Hangers are supplied unassembled in order to prevent damage during shipping. It only takes a few seconds to assemble plate hanger brackets and springs (see instructions below).
A brass-plated wall hook of the appropriate size is included with each plate hanger.
Current Page: Plate Hangers